Technical Manual - Fagor PS-50/200-260-330 TP2 Manuel D'utilisation

4. TECHNICAL MANUAL

4.1. Handle use (in the event of a power failure)
In the event of a power or equipment failure (machine stoppage when the cylinder
is hot) it is essential to immediately isolate the ironing bands from the cylinder.
To do this, insert a thick, very damp cloth of the correct size (barely wrung out) into the machine
by operating it using the provided handle (the handle must be available at all times, its initial
position is on the right-hand machine panel).
Insert the handle in the hole in the right machine panel after having removed the wing screw
to tilt the red flap (to be able to insert the handle). The machine cannot start when the screw is
removed and an alarm will appear if START is pressed (Alarm 2).
Turn the handle anticlockwise continuously until the fabric has passed through the machine
several times and sufficiently to cool and protect the cylinder and the bands.
At least two people are needed to carry out this operation in an emergency, one or two people
to infeed the laundry while another turns the handle.
Refit the wing screw on the right side of the machine after the operation because it activates a
safety contact that authorises the machine to be started.
Red flap to be tilted to insert the handle
(remove the wing screw)
Handle, to be
turned
anticlockwise
43