Seat Functions And Operation; Weight And Height Adjustment; Fore/Aft Adjustment With Control Carrier Equipment - Grammer ACTIMO EVOLUTION Mode D'emploi

Masquer les pouces Voir aussi pour ACTIMO EVOLUTION:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 32

Seat functions and operation

* if fitted
24

Weight and height adjustment

The seat is adjusted for the driver's weight
automatically when the driver takes place on
the seat. For this reason no additional
handling is required.
The seat height can be set pneumatically and
is continuously adjustable. It should not be set
until the automatic weight adjustment has
been completed.
Press the rocker switch at the top or at the
bottom to move the seat upwards or
downwards. If adjustment reaches the top or
bottom end stop, the height will be adjusted
automatically, so as to ensure a minimum
spring travel.
Release the rocker switch, when the desired
height position or the upper end stop is
reached.
In order to avoid compressor damage
during height adjustment or until the upper
end stop is reached, the compressor must be
operated no longer than 1 minute.
Fore/aft adjustment with control
carrier equipment *
The fore/aft adjustment is released by lifting
the locking lever.
WARNING! Risk of accident!
Do not operate the locking lever
while driving.
The locking lever must latch into the
desired position. It should not be possible to
move the driver seat into another position
when it is locked.
Do not lift the locking lever with your leg
or calf.
GB

Publicité

Table des Matières
loading

Table des Matières