Electrical Connection; Technical Data; Initial Operation - Kuppersbusch KMI8500.0 Mode D'emploi

Installation

Electrical connection

• The electrical connection must be carried out by a qualified
electrician who is authorised to carry out such work!
• Statutory regulations and the connection specifications issued by
the local power supply company must be observed.
• When connecting the appliance it must be ensured that there
is a device which makes it possible to universally disconnect it
from the mains with a contact opening width of at least 3mm.
Line-protecting switches, fuses or contactors are suitable cut-out
devices. When connecting and repairing the appliance discon-
nect it from the electricity supply with one of these devices.
• The earth wire must be sufficiently long so that if the strain relief
fails, the live wires of the connecting cable are subjected to
tension before the earth wire.
• Any superfluous cable must be removed from the installation
area beneath the appliance.
• Make sure that the local mains voltage is the same as the volt-
age on the rating label.
• Full protection against accidental contact must be ensured on
installation.
• Attention: Incorrect connection may result in the power
electronics unit being destroyed.
Power supply
Mains voltage: 380-415V 3N~, 50/60Hz
Component rated voltage: 220-240V
Mains cable available in the factory
• The hob has been fitted with a temperature-resistant connection
cable in the factory.
• Connection to the mains is carried out in accordance with the
circuit diagram, unless the connection cable is already fitted with
a plug.
• If the mains supply cable of this appliance is damaged, it has to
be replaced by the manufacturer, the Customer Service of the
manufacturer or by another qualified person to avoid danger.
Electrical connections

Technical Data

Hob dimensions
Height/ Width/ Depth mm
Cooking zones
front left cm / kW
back left cm / kW
back right cm / kW
front right cm / kW
Bridging function cm / kW
Hob kW
Fan kW
Plasma kW
* Power when the power boost function is activated

Initial operation

Once the hob has been installed and the power supply has been
provided (mains connected) an automatic test of the controls will be
carried out and information for Customer Service will be indicated.
Important
No items may be on the touch control sensor keys when the appli-
ance is being connected!
Briefly wipe over the surface of the hob with a sponge and soapy
water and then dry with a clean cloth.
GB
170 x 830 x 515
19 x 21 / 1.6 (1.85)*
19 x 21 / 2.1 (3.00)*
19 x 21 / 1.6 (1.85)*
19 x 21 / 2.1 (3.00)*
39 x 21 / 3.7
7.4
0.115
0.01
43