Troubleshooting - Gaggia Milano CADORNA STYLE RI9600 Mode D'emploi

English
34

Troubleshooting

Problem
The machine does not
switch on.
The drip tray fills quickly. This is normal. The machine uses
The display
continuously shows the
"coffee pucks container
full" icon.
The machine says to
empty the coffee pucks
container even if the
container is not full.
Impossible to remove
the brew group.
4219-450-07541 MANUAL GAG. CAD. PLUS EN-FR 120US rev_2.indd 34
This chapter summarises the most common problems you may encounter while
using the machine. If you are unable to resolve the problem using the information
given below, visit the FAQ sections on www.gaggia.com or www.gaggia.it or
contact the Customer Service Centre in your country.
Cause
The machine is not connected.
water to rinse the internal circuit
and the brew group. Part of the
water flows through the internal
system directly into the drip tray.
The coffee pucks container has
been emptied when the machine
was off.
The coffee pucks container has
been put back too quickly.
The machine has not reset the
counter last time the coffee pucks
container has been emptied.
The brew group is not in the correct
position.
The coffee pucks container has not
been removed.
Solution
Check that the power cord has been inserted
correctly.
Empty the drip tray when the red indicator
emerges from the grid of the drip tray.
Tip: Place a cup under the dispensing spout to
gather the rinse water.
Always empty the coffee pucks container when
the machine is on. If you empty the coffee
pucks container when the machine is off, the
coffee cycle counter does not reset. In this
case, the display shows the icon even if the
container is not full.
Always wait about 5 seconds when you replace
the coffee pucks container. This way, the
counter will reset to zero.
Always wait about 5 seconds when you replace
the coffee pucks container. This way, the
coffee grounds counter will reset to zero.
Always empty the coffee pucks container when
the machine is on. If you empty the coffee
pucks container when the machine is off, the
coffee cycle counter does not reset.
Close the service door. Switch the machine off
and then back on. Wait for the display to show
the ready message, then remove the brew
group.
Remove the coffee pucks container before
removing the brew group.
23/04/2020 09:31:35