Trouble Shooting Guide; Insufficient Water Onto The Brushes; The Machine Does Not Clean Satisfactorily; The Squeegee Does Not Dry Perfectly - COMAC OMNIA 26 Mode D'emploi

INSUFFICIENT WATER ONTO THE BRUSHES

INSUFFICIENT WATER ONTO THE BRUSHES INSUFFICIENT WATER ONTO THE BRUSHES INSUFFICIENT WATER ONTO THE BRUSHES
1. Make sure that the cock is open (1). In this case the signal lamp must be on (2)
2. Make sure that there is water in the solution tank
3. In the machines with automatic version check that the solenoid valve switch is on
4. Clean the solution filter

THE MACHINE DOES NOT CLEAN SATISFACTORILY

THE MACHINE DOES NOT CLEAN SATISFACTORILY
THE MACHINE DOES NOT CLEAN SATISFACTORILY THE MACHINE DOES NOT CLEAN SATISFACTORILY
1. Check the condition of the brushes and replace them, if necessary. The brushes have
to be changed when the bristles reach around 15mm. To work with worn brushes
can cause floor damages.
2. Check that the brushes pressure is sufficient (see under "BRUSHES PRESSURE")
3. Use a different kind of brushes to the ones fitted as standard. For cleaning
operations on floors where the dirt proves to be particularly resistant, we
recommend using special brushes which may be supplied optionally according to
needs (see under "CHOICE AND USE OF BRUSHES")

THE SQUEEGEE DOES NOT DRY PERFECTLY

THE SQUEEGEE DOES NOT DRY PERFECTLY
THE SQUEEGEE DOES NOT DRY PERFECTLY THE SQUEEGEE DOES NOT DRY PERFECTLY
1. Check that the squeegee is clean
2. Check the squeegee adjustments (see under "MACHINE PREPARATION")
3. Clean the whole suction group (see under "DAILY MAINTENANCE")
4. Replace the rubbers, if worn (see under "WEEKLY MAINTENANCE")

TROUBLE SHOOTING GUIDE

TROUBLE SHOOTING GUIDE
TROUBLE SHOOTING GUIDE TROUBLE SHOOTING GUIDE
47