General Rules Of Security - COMAC OMNIA 26 Mode D'emploi

Masquer les pouces Voir aussi pour OMNIA 26:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

The rules below have to be followed carefully in order to avoid damages to the operator and to the machine.
The rules below have to be followed carefully in order to avoid damages to the operator and to the machine.
The rules below have to be followed carefully in order to avoid damages to the operator and to the machine.
The rules below have to be followed carefully in order to avoid damages to the operator and to the machine.
r Read the labels carefully on the machine. Do not cover them for any reason and replace them immediately if damaged
r The machine must be used exclusively by authorized staff that has been instructed for its use
r During the working of the machine, pay attention to other people and especially to the children
r Do not mix different detergents, avoiding harmful odours
r Do not place any liquid containers onto the machine
r The storage temperature has to be between -25 ° C and +55 ° C
r The perfect operating temperature should be between 0 ° C and 40 ° C
r The humidity should be between 30 and 95%
r Do not use the machine in explosive atmosphere
r Do not use the machine as a means of transport
r Do not use acid solutions which could damage the machine and/or the persons
r Avoid working with the brushes when the machine stands still, in order to prevent floor damages
r Do not vacuum inflammable liquids
r This appliance is not suitable for picking up hazardous dust
r In case of fire, use a powder extinguisher. Do not use water
r Do not strike shelvings or scaffoldings, where there is danger of falling objects
r Adapt the utilization speed to the adhesion conditions
r Do not use the machine on areas having a higher gradient than the one stated on the number plate
r When the machine is in parking position, take off the key and insert the parking brake
r The machine has to carry out simultaneously the operations of washing and drying. Different operations have to be carried out
in areas which are not permitted for the passage of non employed staff. Signal the areas of moist floors with suitable signs
r If the machine does not work properly, check by conducting simple maintenance procedures. Otherwise, it is better to ask for
COMAC technical service
r Where parts are required, ask for ORIGINAL spare parts to an agent and/or to an authorized dealer
r Use only original COMAC brushes indicated in the paragraph "CHOICE AND USE OF BRUSHES"
r In case of danger act immediately upon the emergency brake
r Take off the key or remove the battery connector before any maintenance, cleaning or parts' replacement is done
r Do not take off the pieces which require the use of tools to be removed
r Before using the machine, check that all doors and coverings are in their position as indicated in this use and maintenance
catalogue
r Do not wash the machine with direct water jets or with high water pressure nor with corrosive material
r Every 200 working hours have a machine check through a Comac service department
r The machine should not be abandoned, because of the presence of toxic-harmful materials (batteries, oil etc.). This disposal
must be subject to the rules which provide for its scrapping in appropriate centres
r Be sure the solution tank is empty before lifting it
r In order to avoid scales on the solution tank filter, do not fill the detergent solution many hours before the machines' use

GENERAL RULES OF SECURITY

GENERAL RULES OF SECURITY
GENERAL RULES OF SECURITY
GENERAL RULES OF SECURITY
38

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Omnia 32Omnia 42

Table des Matières