Squeegee Assembly; Squeegee Adjustment; Cover Assembly Omnia 42 - COMAC OMNIA 26 Mode D'emploi

9. 9. 9. 9.

SQUEEGEE ASSEMBLY

SQUEEGEE ASSEMBLY SQUEEGEE ASSEMBLY SQUEEGEE ASSEMBLY
The floor-wiper is supplied separately, dismantled from the machine, for packing
reasons. It must be installed as illustrated, first threading left pin (1) of the floor-wiper
into the left slot on the arm and then right pin (2) into the right slot, being careful to
keep the spring and the washer above the arm's flat bar. This can be simplified by first
loosening the handwheel on the pin. Then retighten the handwheel to clamp the floor-
wiper into position.
Now insert the floor-wiper tube into its specific fitting sleeve (3)
10. 10. 10. 10.

SQUEEGEE ADJUSTMENT

SQUEEGEE ADJUSTMENT SQUEEGEE ADJUSTMENT SQUEEGEE ADJUSTMENT
During operation the rear rubber must be slightly and uniformly bent back about 5 mm
along its entire length.
If it is necessary to increase curvature of the rubber in the central section then the
wiper's body must be inclined backwards by rotating adjustment unit (1) counter-
clockwise. To increase curvature of the rubber on the sides of the floor-wiper rotate
adjustment unit (1) clockwise.
The floor-wiper must be adjusted in height depending on rubber wear. Adjust height by
rotating knob (2) clockwise (tightening) to lift the floor-wiper and counter-clockwise
(loosening) to lower it.
Note: The right and left wheels must be adjusted equally so that the floor-wiper works Note: Note: Note:
perfectly parallel with the floor.
11. 11.

COVER ASSEMBLY OMNIA 42

COVER ASSEMBLY OMNIA 42
11. 11. COVER ASSEMBLY OMNIA 42 COVER ASSEMBLY OMNIA 42
The covers of the brushes base of Omnia 42 are packed separately from the machine.
Before the assembling operations are carried out, make sure that the battery connector
has been uncoupled. Then, proceed as follows:
1. Loosen the knobs on the brushes base
2. Insert the cover as shown in the figure
3. Tighten the knobs
MACHINE PREPARATION MACHINE PREPARATION
MACHINE PREPARATION MACHINE PREPARATION
35
1
3
2