Telecom Behnke 20 Serie Instructions page 56

Code Parameter
20 = activated after receiving an emergency call (according to EN 81-70)
(from V1.40 or later)
21 = activated while speaking in two-way communication (from V1.42 or
later)
22 = activated while listening in two-way communication (from V1.42 or
later)
23 = controls the additional relay board (V 1.51 or later)
24 = IP video routing (V.161 or later)
Relay activation interval for relay 2: Default setting: 5
13 1 = 1 second
2 = 2 seconds
:
30 = 30 seconds (up to V1.60)
:
90 = 90 seconds (from V1.61 or later)
Relay activation codes Relay 2: Default settings: cf. configurations step 12
14 1. activation code
15 2. activation code
Activation codes consist of cyphers only and each activation code may be
up to 4 characters long.
Group call /interception protection/ non-terminable call / EN 81-28/70
operation: Default setting: 0
20 0 = inactive (group call, interception protection and non-terminable call
inactive)
1 = dial telephone number 1 (interception protection & non-terminable
call)
2 = dial telephone number 1 and 2 (interception protection &
non-terminable call)
:
8 = dial telephone number 1 and 8 (interception protection &
non-terminable call)
9 = dial telephone number 1 and 9 (interception protection &
non-terminable call)
www.behnke-online.com
Manual Door intercom devices a / b Series 20 / 30 / 50
Configuration and Set-up
GB
Confirmation
#
#
#
#
#
#
#
:
#
#
#
#
:
#
#
56