Controls - Siemens TE501 Série Mode D'emploi

Controls

Power on/off switch O / I
The power on/off switch O / I (9) is used to
switch the appliance on or to switch it off
completely (power supply off).
Important: To switch off, use the service
button (12)�
A
Service button
When the service button (12) is pressed
briefly, the appliance rinses and switches
off. If the service button (12) flashes, the
service programme needs to be run� Press
and hold the service button (12) to start
the service programme� The service button
(12) flashes while the service programme is
running and turns off when the programme
has ended�
B
Steam button
Press the steam button (11) to generate
steam for frothing milk�
C
Start button
Press the start button (10) to start preparing
a drink� Press again during drink preparation
to stop the dispensing process early.
LED display
The various LEDs light up and flash to
indicate the following:
D
lights up The water tank is empty and
needs to be refilled.
D
flashes The water filter is exhausted
and needs to be replaced�
Important: When you first take
the appliance into operation
this flashing light does not
signify "Change filter" (see
"Setting up the appliance",
see page 24)
E
lights up The bean container is empty
and needs to be refilled.
F
lights up The steam valve needs to be
opened or closed�
F
flashes Depending on the setting,
steam or hot water is coming
out of the milk frother�
G
lights up When
the "coffee strength" rotary
knob, the symbol lights up
while ground coffee is being
dispensed�
H
lights up The drip tray is missing or has
not been inserted correctly.
Insert the drip dray.
H
flashes The trays are full. Empty the
trays and reinsert them.
I
lights up The brewing unit door is open�
Close the door�
I
flashes Remove and clean the
brewing unit�
G
is selected using
en
23