Siemens TE501 Série Mode D'emploi page 35

Cleaning the milk frother
The milk frother (6) must be cleaned after
each use in order to remove residues�
Important: Let the milk frother cool down
before you remove it.
Dismantle the milk frother for cleaning:
1� To remove, take hold of the metal sleeve
and pull it downwards and off�
2� Twist the steam nozzle (6d) anticlock­
wise and remove it�
3� Remove the frothing tube (6c).
6c
4� Clean the individual parts with a
detergent solution and a soft brush�
If necessary, soak in a warm detergent
solution� Clean the air hole (6e)
thoroughly.
1
6d
2
6e
5� Rinse all parts with clean water and dry.
6� Fit the steam nozzle (6d) and frothing
tube (6c) back into the metal sleeve�
6c
1
7� Twist the steam nozzle clockwise until
the marks are aligned�
8� Attach the milk frother to the steam
valve� Check that the red mark on the
steam valve is covered�
Risk of scalding!
A
Only use the appliance when the milk
frother (6) is completely assembled and
fitted.
en
6d
2
31