Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
If you wish to change the default degree of
water hardness, or if you have inserted a
water filter, proceed as follows:
1� Turn the rotary
knob (13) to position
2� Press and hold buttons
A
(12) simultaneously for at least
5 seconds� The set water hardness is
indicated by the number of LEDs that
now light up�
3� Now press the start button (10) repeat
edly until the required water hardness
is indicated, e� g�, for water hardness 3,
D
E
LEDs
,
and
4� Press and hold the start button (10)
for at least 5 seconds� The set number
of LEDs will light up to indicate that
the selected water hardness has been
saved successfully.
Important: If a water filter is used (see
"Accessories"), proceed as follows, see
"Water filter".
Note: If no button is pressed within
90 seconds, the appliance switches to
standby mode without saving the new
settings. In this case, the previously saved
water hardness setting is retained�
Automatic switch-off
Here you can set the period of time after
which the appliance should switch off
automatically following the last drink
preparation� A time between 15 minutes and
4 hours can be set� To save power you can
specify a shorter period.
1� Turn the rotary
knob (13) to position
2� Press and hold buttons
A
(12) simultaneously for at least
5 seconds� The time after which the
appliance should switch off is indicated
by the number of LEDs that now light up.
B
(11) and
F
will light up�
B
(11) and
3� Now press the start button (10) repeat
edly until the required number of LEDs
light up to indicate the switchoff time:
D
= 15 minutes
D
E
and
= 30 minutes
D
E
F
,
and
= 45 minutes
D
E
F
G
,
,
and
D
E
F
G
,
,
,
and
D
E
F
G
,
,
,
,
4� Press and hold the start button (10) for
at least 5 seconds� The set number of
LEDs will light up to indicate that the
selected switchoff time has been saved
successfully.
Note: If no button is pressed within
90 seconds, the appliance switches to
standby mode without saving the new
settings. In this case, the previously saved
switchoff time is retained.
Setting the brewing temperature
The brewing temperature can also be set�
1� Turn the rotary
knob (13) to position
2� Press and hold buttons
A
(12) for at least 5 seconds� The set
brewing temperature is indicated by the
number of LEDs that now light up�
3� Now press the start button (10) repeat
edly until the required number of LEDs
light up to indicate the temperature:
D
LED
= low
D
E
LED
and
D
E
LED
,
,and
4� Press and hold the start button (10) for
at least 5 seconds� The set number of
LEDs will light up to indicate that the
selected temperature has been saved
successfully.
Note: If no button is pressed within
90 seconds, the appliance switches to
standby mode without saving the new
settings. In this case, the previously saved
brewing temperature setting is retained�
= 1 hour
H
= 2 hours
H
I
and
= 4 hours
B
(11) and
= medium
F
= high
en
27
Publicité
Chapitres
Table des Matières
