Tips On Saving Energy - Siemens TE501 Série Mode D'emploi

en
Cleaning the brewing unit
Clean the brewing unit regularly.
To pre­clean the brewing unit automatically:
Press the service button (12) briefly. The
appliance will rinse if coffee was dispensed
previously. It then switches off.
In addition to the automatic cleaning
programme, the brewing unit (5a) should be
removed regularly for cleaning (Figure E at
the beginning of the instructions)�
1� Press the power on/off switch O / I (9) to
switch off the appliance� All lights go off�
2� Open the door (5b) to the brewing unit�
3� Slide the red lock (5d) on the brewing
unit (5a) completely to the left.
4� Press the eject lever (5c) down fully.
The brewing unit is released�
5� Grasp the brewing unit (5a) by the
recessed grips and remove carefully.
6� Remove the cover (5e) of the brewing
unit and rinse the brewing unit (5a)
thoroughly under running water.
7� Thoroughly clean the brewing unit sieve
under the running water�
32
Important: Do not clean with detergent or
other cleaning agents and do not put it in
the dishwasher�
8� Wipe out the inside of the appliance
thoroughly with a damp cloth and
remove any coffee residues.
9� Allow the brewing unit (5a) and the
interior of the appliance to dry.
10� Replace the cover (5e) on the brewing
unit and reinsert the brewing unit (5a)
fully into the appliance.
11� Press the eject lever (5c) up fully.
12� Slide the red lock (5d) fully to the right
and close the door (5b)�

Tips on saving energy

● Switch off the fully automatic espresso
machine when not in use� To do this,
press the service button (12)� The
appliance rinses and switches off�
● If possible, do not interrupt coffee
or milk froth dispensing� Stopping a
process prematurely results in higher
energy consumption and the drip tray
fills up more quickly.
● Descale the appliance regularly
to avoid a build­up of limescale.
Limescale residue results in higher
energy consumption.