Water Filter - Siemens TE501 Série Mode D'emploi

4� Assemble the milk frother. Only use
the appliance when the milk frother (6)
is completely assembled and fitted.
5� Lift the water tank lid (17)�
6� Remove and rinse the water tank (16)
and fill it with fresh cold water. Do not fill
above the max mark�
7� Replace the water tank (16) and push it
firmly downwards into place.
8� Close the water tank lid (17)�
9� Fill the bean container (1) with
coffee beans (for preparation using
ground coffee see "Preparation using
ground coffee").
10� Press the power on/off switch O / I (9) to
switch on the appliance� LED
F
and LED lights up�
11� Place a container under the milk frother
outlet (6)�
12� Carefully pull out the milk frother (6)
to open it� The appliance rinses out
the milk frother (6) with water� LED
flashes.
F
13� When LED
press in the milk frother (6) to close it�
The appliance heats up and rinses� Some
water will run out of the coffee outlet� When
A B
buttons (12),
up, the appliance is ready for use.
Switching off the appliance
The factory settings of the fully automatic
espresso machine are programmed for
optimal performance� The appliance
switches off automatically after a specific
time (the length of time can be adjusted,
see "Settings – Automatic switch­off").
D
flashes
lights up constantly,
C
(11) and (10) light
Exception: The appliance switches off
without rinsing if only hot water or steam
was dispensed�
To switch the appliance off manually before
this, press the service button
appliance rinses and switches off�
Note: If the appliance is being used for the
first time, the service programme has been
run, or the appliance has not been operated
for a long period, the first beverage will
not have the full aroma and should not be
consumed�
When the fully automatic espresso machine
is first used, you will achieve a suitably thick
and stable "crema" only after the first few
cups have been dispensed�
If the appliance is in use for a long period
of time, water droplets will form on the
ventilation slits� This is normal�

Water filter

Using a water filter can prevent a build­up
of limescale deposits�
A new water filter must be rinsed before it
can be used� To do this, proceed as follows:
F
1� Press the water filter firmly into the
empty water tank with the aid of the
measuring spoon (18)�
2� Fill the water tank (16) with water up to
the max mark�
en
A
(12)� The
25