Mounting The Rapid Shutdown Controller - SMA RSB-2S-US-10 Manuel D'installation

SMA Solar Technology America LLC
5. Align the Rapid Shutdown box over the drill holes
and attach it using suitable screws and washers.
5.4

Mounting the Rapid Shutdown Controller

Additionally required mounting material (not included in the scope of delivery):
☐ 4 screws suitable for the support surface (diameter: 4 mm (0.16 in))
☐ Where necessary, 4 screw anchors suitable for the support surface and the screws
Procedure:
1.
Risk of injury due to damaged cables
There may be power cables or other supply lines (e.g. gas or water) routed in the wall.
• Ensure that no lines are laid in the wall which could be damaged when drilling holes.
2. Unscrew the 4 screws in the upper enclosure part of
the Rapid Shutdown Controller using a cross-head
screwdriver (PZ 2), remove the upper enclosure part
and place to one side.
3. Mark the positions of the drill holes using the 4 screw holes in the lower enclosure part of the
Rapid Shutdown Controller as a guide (see the rear side of the Rapid Shutdown Controller for
hole distances).
4. Place the Rapid Shutdown Controller to one side and drill the drill holes at the positions
marked.
5. Insert screw anchors into the drill holes if the support surface requires them.
6. Screw the lower enclosure part of the Rapid Shutdown Controller to the wall using the screws.
Installation Manual
CAUTION
5 Mounting
RSS-US-IA-xx-14 17