Mounting; Mounting Position; Installing The Module - SMA RoofCommKit-P2-US Instructions D'installation

4 Mounting

4 Mounting
4.1

Mounting position

A
Figure 3 : Communication assembly in the inverter with mounting position for the module
Position Designation
A Communication assembly
B
Module slot M2
4.2

Installing the Module

Procedure:
1. Remove the enclosure lid of the DC Connection Unit. Unscrew all screws (TX25) and remove
the enclosure lid towards the front.
2. Set the screws and the enclosure lid aside and store safely.
3. Plug the 20-pin connector with the long pin side into
the socket terminal strip on the back of the module.
4. Plug the module into the module slot M2. Perform the following steps:
12 RoofCommKit-P2-US-IA-xx-11
X 1
X 2
D I S P
L A Y
F C C
I D : S
I C : 9
V F - K
4 4 0 A
P
- K P 2
0
M a x
. 3 0 V
B A T
D C
M F R
A
U S B
B
SMA Solar Technology America LLC
B
Installation manual