SMA RSB-2S-US-10 Manuel D'installation page 15

SMA Solar Technology America LLC
Risk of falling when working on the roof
There is a risk of falling or slipping when working on the rooftop. Observe the applicable
accident prevention regulations for work on rooftops.
• Before stepping on the rooftop, ensure the load bearing capacity of all parts subjected to
load.
• In accordance with the accident prevention regulations, a safety harness must be worn or a
safety scaffold must be used.
• Use fall protection.
Damage to the PV module due to screws being too long
The length of the screws must be suitable for the distance between the Rapid Shutdown Box and
the underside of the PV module.
• Make sure that the PV module will not be damaged by the screws being used.
Additionally required mounting material (not included in the scope of delivery):
☐ The required fastening material must be selected according to the mounting system used.
☐ The mounting material must be made of stainless steel.
☐ Diameter of the screws: maximum 8 mm (0.3 in)
Procedure:
1. Insert the T-head bolts into the mounting system and turn by 90°. This will firmly anchor the
screws in the rack rail.
2. Place the Rapid Shutdown Box onto the anchored
screws. Here, insert the screws into the oblong holes
up to the desired fastening point.
Installation Manual
WARNING
NOTICE
5 Mounting
RSS-US-IA-xx-14 15