To Empty The Spent Mandrel Container; Maintenance And Care; To Oil Jaws; To Change Jaws - Gesipa TAURUS 1 Mode D'emploi Et Liste Des Pièces De Rechange

GB
7.5

To empty the spent mandrel container

• Thespentmandrelcontainer(No.36)mustbeemptiedingoodtime;overfillingwillcause
the blind rivet setting tool to malfunction.
• Unscrew the spent mandrel container (No. 36) by turning anticlockwise, collect spent
mandrels in suitable container.
• Screw on spent mandrel container (No. 36).
8.

Maintenance and care

The complete grip mechanism must be maintained regularly.
8.1

To oil jaws

• Disconnect the blind rivet setting tool from the compressed air supply.
• Unscrew steel head sleeve (No. 2).
• Dip the complete jaw mechanism up to the O-ring (No. 3) into an oil batch or wet jaws
(No. 5) with oil and allow to drip off.
• Reassemble in reverse order.
8.2

To change jaws

• Disconnect the blind rivet setting tool from the compressed air supply.
• Unscrew steel head sleeve (No. 2).
• Unscrew jaw housing (No. 4).
• Remove jaws (No. 5).
• Clean jaw housing (No. 4) and grease sliding surfaces.
• Fit new jaws (No. 5) from the front (they are held by the grease).
• Reassembleinreverseorder,ensuringthatallpartsarefixedtight.
8.3

To top up hydraulic oil

Follow correct sequence!
Wear safety goggles!
• Disconnect the blind rivet setting tool from the compressed air supply.
• Unscrew steel head sleeve (No. 2).
• Unscrew oil screw plug (No. 12) and seal (No. 13) using T20 Torx screwdriver.
• Screwonsuppliedoilrefillreservoirwithcover.
20
Danger of oil escaping at high pressure.