11.
Repairs
Repairs under warranty are carried out by the manufacturer. Repairs outside the warranty pe-
riod should only be carried out by skilled technical personnel. Failure to observe the assembly
and setting procedures and operation by non-skilled personnel may result in serious damage to
the riveting tool. In case of doubt, always send in the device to the manufacturer.
12.
Troubleshooting
12.1
Blind rivet is not set
Cause
Jaws soiled
Jaws worn
Insufficient compressed air
12.2
Spent mandrel is not conveyed automatically into the container
Cause
Wrong nosepiece used
Nosepiece worn
Spent mandrel jammed in jaws
Spent mandrel container full
Corrective measures
Clean and oil sliding surfaces (see 10.1)
Replace (see 10.1)
See operating pressure (see 3)
Corrective measures
Exchange according to table (see 6)
Replace
Clean jaws and jaw housing and oil sliding
surfaces; replace if worn (see 10.1)
Empty (see 9)
GB
25