Start-Up; To Attach Spent Mandrel Container; Selecting And Changing The Nosepiece; To Set A Blind Rivet - Gesipa TAURUS 1 Mode D'emploi Et Liste Des Pièces De Rechange

7.

Start-up

Before starting the blind rivet setting tool, read and observe the operating instructions and
safety information and keep in a safe place. Have technical personnel connect the com-
pressed air supply to the blind rivet setting tool.
7.1

To attach spent mandrel container

Fully screw on spent mandrel container (No. 36) by turning clockwise.
7.2

Selecting and changing the nosepiece

Caution!Alwaysfitthenosepiececorrespondingtothesizeoftheblindrivet(selectfrom
table in Section 6).
To change the nosepiece
• Disconnect the blind rivet setting tool from the compressed air supply.
• Unscrew nosepiece (No. 1) from steel head sleeve (No. 2).
• Screw in selected nosepiece (No. 1) and tighten.
7.3

To set a blind rivet

• Connect the blind rivet setting tool to the compressed air supply.
• Inserttheblindrivetinthenosepiece(No.1)andusingthetoolfitasfarasitwillgointhe
hole in the material to be joined.
• Press trigger (No. 40) until the mandrel breaks off.
• Release trigger (No. 40).
• The spent mandrel is automatically conveyed into the spent mandrel container (No. 36)
(see Section 7.5).
7.4

To suck in and hold a blind rivet

This function is used to hold the blind rivet in the nosepiece for riveting vertically downward.
• Using a pin (e.g. rivet mandrel), push the slide valve (No. 39) in the tool head as far as it
will go to the left or right.
• After the blind rivet setting tool has grabbed the rivet, push up the slide (No. 41) so that it
locks in. To switch off the suction, push down the slide (No. 41).
• The complete suction function of the blind rivet setting tool is deactivated by pushing
back the slide valve (No. 39).
GB
19