Connection Of Power Cable; Safety Thermal Breaker; Use Instructions (For The User); Residual Risks (For The User) - Hendi 225172 Mode D'emploi

CONNECTION OF POWER CABLE

The terminal board is on the rear panel of the appli-
ance. Open the terminal board cover by obtaining
leverage with a screwdriver on the two side fins.
Loosen the cable gripper screw and allow the cable
to pass through it. Arrange the conductors so that
the earth conductor is the last to detach from its ter-
minal if the cable goes into a state of faulty traction.
Connect the phase conductor to the terminal marked
with the letter „L", the neutral conductor to the ter-
minal marked with the letter „N" and the earth con-
ductor to the terminal marked with the symbol

SAFETY THERMAL BREAKER

The appliance has safety thermal breaker. It pro-
tects against excessive dangerous over-tempera-
tures which could be accidentally generated inside

5. USE INSTRUCTIONS (FOR THE USER)

This appliance is not intended for use by persons (in-
cluding children) with reduced phycal, sensory or
mental capabilities, or lack of experience and
knowledge. Unless they have beengiven supervision
or instruction concerning use of appliance by a per-
son responsible for their safety.
Children should be supervised to ensure that they do
not play with the appliance.
For first use, we advise you to let the appliance to
run load-free at maximum temperature for about
one hour. In this way, any unpleasant smells due to
thermal insulation and residual work grease are
eliminated.
This appliance must be used solely for the purpose
for which it was expressly designed, i.e. cooking foods

6. RESIDUAL RISKS (FOR THE USER)

After a cooking operation, open the door cautiously,
to avoid a violent outflow of heat which could cause
burns.
While the oven is in operation, pay attention to the
hot zones (marked on the appliance) of its external
surfaces.
Place the machine on a bench or similar support, at
a height of at least 85 cm from the floor.
The bench or support must be able to support the
weight of the machine and house it correctly.
Tighten the ring-nut of the cable gripper and close
the terminal board cover. The appliance must be
connected to an equipotential system whose effi-
ciency must first be checked according to current
legal regulations. This connection must be made be-
tween different appliances by using the appropriate
terminal marked with the symbol
conductor must have a minimum diameter of 2,5 mm
The equipotential terminal is at the rear of the appli-
ance.
.
the appliance. If the device is tripped, it interrupts
electrical power to the appliance and thus prevents
it from operating.
in the oven. Any other use is considered unsuitable.
The appliance can be used: for all oven cooking of
deserts, pizzas, meat, fish, vegetables, as well as for
gratinating, and for re-conditioning cooled and frozen
foods.
When placing food in the cooking compartment, leave
a space of at least 40 mm between pans in order not
to over-obstruct air circulation.
Do not use pans with higher than necessary edges:
edges are barriers which prevent the circulation of
hot air.
Warm up the oven before every cooking operation to
obtain maximum uniformity.
Do not salt foods in the cooking compartment.
The appliance contains electrical parts and must
never be washed with a jet of water or steam.
The appliance is electrically connected: before at-
tempting any cleaning operation, cut power to the
appliance.
Do not use the door handle to move the appliance
(the glass panel may break).
When the tilting door is wide open, do not use the
internal surface to place objects to avoid
damaging permanently the door hinges.
. The equipotential
2
EN
5