Technical Service; General Warnings; Technical Specifications - Hendi 225172 Mode D'emploi

1. TECHNICAL SERVICE

A technical check-up once or twice a year helps prolong the life of the appliance and guarantees better op-
eration. Make sure that assistance is carried out solely and exclusively by qualified personnel. For any spare
parts orders or for any information about the appliance, always mention the serial number and model (data
indicated on the „technical data" plate at the rear of the oven).

2. GENERAL WARNINGS

Very important!: keep this instruction book together with the appliance for future consultation. These warn-
ings were drafted for your safety and for that of others. Please read them carefully before installing or using
the appliance:
• The warehouse inside temperature must not be
lower than -9°C; otherwise, the thermostat (regu-
lation and safety thermostat) control devices of
the machine will be damaged. Failure to observe
this prohibition invalidates any responsibility of
the manufacturer of the machine.
• The appliance is intended for professional use and
must be utilised by qualified personnel trained to
use it.
• Any modification which may be necessary on the
electrical system to enable installation of the ap-
pliance, must be carried out solely by competent
personnel.
• It is dangerous to modify or attempt to modify the
N.B.: Improper or incorrect use and failure to observe the installation instructions shall release the
manufacture from all responsibility. In this connection, the directives in the „POSITIONING" paragraph
must be strictly observed.

3. TECHNICAL SPECIFICATIONS

Model
Dimensions of appliance LxDxH
Weight of appliance
Max absorted power
Convection heating element
Maximum load per pan
Power supply voltage
Appliance class
Power cable diameter
Type of cable
Electric cable connection
Water pressure
The noise level of the appliance in operation is below 70 dB (A).
The „technical data" plate is positioned on the rear panel of the appliance.
characteristics of this appliance.
• Never clean the appliance with direct water jets,
because, if any water enters, it could limit the ma-
chine's safety.
• Before doing any maintenance or cleaning jobs,
disconnect the appliance from the electrical
mains and allow it to cool.
• Do not attempt to carry out the periodic controls
or any repairs by yourself. Contact the nearest
Service Centre and use only original spare parts.
• When the tilting door is wide open, do not put any-
thing on the surface, because the door hinges could
be irreparably damaged.
225172
590x695x590 mm
34 Kg
2,8 kW
2,7 kW
1,5 kg
230 V~ (50/60 Hz)
I
3x1,5 mm²
H07RN-F
Type Y
–
225028 (with humidification)
590x695x590 mm
34,2 Kg
2,8 kW
2,7 kW
1,5 kg
230 V~ (50/60 Hz)
I
3x1,5 mm²
H07RN-F
Type Y
100-200 kPa
EN
3