Instructions For The Installer; Fitting The Feet; Positioning; Electrical Connection - Hendi 225172 Mode D'emploi

4. INSTRUCTIONS FOR THE INSTALLER

The following instructions are aimed at the qualified
installer, to ensure that he carries out the installa-
tion, adjustment and maintenance operations as
correctly as possible and according to current legal
regulations. Any operation must be performed with
electrical power cut to the appliance.

FITTING THE FEET

The feet are inside the appliance and must be se-
cured on the four threaded holes on the base. If nec-

POSITIONING

Position the appliance perfectly horizontally on a ta-
ble or similar support (the table or support must be
at least 85 cm above the floor). Once you have put the
machine, it should not exceed height of 1.60 meter
from the floor; position it at a distance of not less
than 10 cm from the side and rear walls, to enable
natural ventilating air to circulate freely around it.
The appliance is ventilated through specific open-
ings on the metal walls of the outer housing, and en-
sures efficiency and long-life. For this reason it is
EN

ELECTRICAL CONNECTION

The appliance must be connected to the electrical mains according to current legal regulations. Before
making the connection, make sure of the following:
• the voltage and frequency values of the power
supply system match the values on the „technical
data" plate affixed on the appliance;
• the limiting valve and the system are able to sup-
port the appliance's load (see the „technical data"
plate);
• the power supply system has an adequate earth
connection according to current legal regulations;
• a omnipolar switch with minimum between-con-
tacts aperture of the overvoltage category III
(4000 V), sized to the load and conforming to cur-
rent legal regulations, is fitted between the appli-
ance and the mains in the direct connection to the
mains;
CONNECTION TO THE WATER MAINS (FOR OVENS PREDISPOSED) – ONLY FOR OVEN HENDI 225028
The appliance must be fed with softened drinking
water, with hardness from 0.5°F to 3°F (it is obliga-
tory to use a softener to reduce the formation of lime
inside the cooking chamber) and pressure in the
range from 100 to 200 kPa (1.0 - 2.0 bar).
Connection to the water mains should be made
4
Before using the appliance, carefully remove the
special adhesive film protecting the parts in stain-
less steel. Do not leave any glue residues on the sur-
faces. If necessary, remove them at once, with an
appropriate solvent.
essary, the height of the feet can be adjusted by
screwing or unscrewing.
strictly forbidden to obstruct these ventilation open-
ings, even partially or for short periods. Failure to
observe this specific prohibition releases the man-
ufacturer of the appliance from all responsibility
and immediately voids any guarantee rights for the
said appliance, because its constructive conformity
has been voluntarily compromised. Furthermore,
the appliance is not suitable for embedding and for
grouped positioning with other identical appliances.
• the omnipolar switch used for connection is easy
to reach when the appliance is installed;
• the yellow/green earth wire is not interrupted by
the switch;
• the power supply, when the appliance is operat-
ing, must not deviate from the rated voltage value
by ±10%;
• make sure that after inserting the power supply
cord into the terminal block it does not come into
contact with any of the cooking range's hot parts.
• if the supply cable is damaged then it must be re-
placed by the manufacturer or by your technical
support or by a qualified person to avoid any risk.
through the threaded 3/4" solenoid-valve on the rear
(on the bottom) of the appliance, fitting in between a
mechanical filter and an on/off tap (before you con-
nect the filter, allow a certain quantity of water to
flow out in order to drain any waste from the pipe).