Locking And Unlocking Your Safe; Bolt-Down Instructions - SentrySafe QAP1BE Manuel Du Propriétaire

Locking and Unlocking Your Safe

NOTICE
Test your code several times before putting valuables inside.
Locking your safe
Close the lid. Once the lid is closed, the safe is securely locked.
A
NOTE: The override key needs to be in the locked position.
Remove and store in a secure location.
NOTE: When not in use – the safe will go into standby mode. This is
a lower power mode. Pressing a button will end the standby mode.
Unlocking your safe
Press any button once to bring the safe out of
A
standby mode.
Enter your programmed user code.
B
–OR–
A
Insert the override key into the keyhole and turn clockwise.
–OR–
For Select Biometric Lock Models Only:
Press any button once or touch the fingerprint scanner to bring the
A
safe out of standby mode.
Swipe a programmed finger.
B
6

Bolt-Down Instructions

Bolting down your safe
Bolt-Down kit contents:
2 Screws
2 Washers
Tools needed to bolt safe to a surface:
Drill
Wrench
9/32in (7.2 mm) drill bit – for drilling into wood
3/8in (9.5 mm) drill bit – for drilling into masonry
Select a suitable location for your Quick Access Pistol Safe. Set the
safe in place, and use the pre-drilled holes provided on the bottom of
the safe to mark the location of the holes to be drilled in the surface.
NOTICE
Do NOT drill from any location inside the safe.
NOTE: This product is intended to be mounted with a horizontal orientation.
Move the Quick Access Pistol Safe while you drill the marked holes in
the surface.
Drill the holes in the surface using the appropriate diameter and depth for the type of hardware
and the mounting surface being used.
Replace the safe over the newly created holes.
A
Install the screws and washers as required.
B
NOTICE
Sentry ® Safe is not responsible for costs incurred if the unit is to be replaced.
Bolting/unbolting the unit is at a consumer's expense and discretion.
7