The Installation Space; Dimensions And Clearances - Monogram ZIFS360NHLH Instructions D'installation

Réfrigérateurs et congélateurs intégraux encastrés 36 po
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Design Guide - Flush Installation

THE INSTALLATION SPACE

Finished Width
4-5/16"
9"
26-3/16" Minimum
Cutout Depth
85"
Finished
Cold Water
Opening
3-1/2"
7"
3-1/2"
Water And Electrical Locations
Electrical and water supply must be located as
shown.
Cutout Depth Beneath a Soffit:
When installed beneath a soffit, the soffit cannot
exceed the 26-3/16" (66.52 cm) installation depth
shown.
The Cutout Depth Must Be 26-3/16" (66.52 cm)
Wooden cleats are required for flush installation. See
Side Cleats on page 30.
Additional Specifications
• A 115 volt 60Hz., 15 or 20 amp power supply is
required. An individual properly grounded branch
circuit or circuit breaker is recommended. Install
a properly grounded 3-prong electrical receptacle
recessed into the back wall. Electrical must be
located on rear wall as shown.
• Water line can enter the opening through the floor
or back wall. The water line should be 1/4" O.D.
copper tubing or QuickConnect
cold water line and water connection location,
long enough to extend to the front of the unit.
Installation of an easily accessible shut-off valve in
the water line is required.
39"
Wall View
5-1/2"
Electrical
Area
75-1/2" From
Floor to Bottom
Suppl
of Electrical Area
3-1/2"
7"
3-1/2"
3-1/2"
kit between the

DIMENSIONS AND CLEARANCES

35"
Case Width
*83-1/2"
at
Rear
Depth Including
Handles 26-7/8"
Product Clearances
These units are equipped with a 3-position door stop.
The factory set 115° door swing can be adjusted to 90°
if clearance to adjacent cabinets or walls is restricted.
90° Door Swing
4" Minimum
to a Wall
90° Door Swing
23-7/8"
Case Behind
Frame
38-3/4"
90°
For a 90° door swing, allow 4" (10.16 cm) minimum
clearance to a wall for framed and stainless steel
models. If the 90° doorstop position is used, pan
access is maintained but pan removal is restricted.
24
25-3/8" Case Depth
* Shipping height. The
product can be adjusted
to fit into a cutout that
is 85" (215.9 cm) max.
*84" From
height. Use leveling
Floor to
legs and wheels for a
Top Frame
maximum 1" (2.54 cm)
height adjustment.
38-3/4" Frame to
Frame Width
115° Door Swing

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Zifs360nhrh

Table des Matières