Step 6 Secure Unit To Wall; Step 7 Adjust Door Swing - Monogram ZIFS360NHLH Instructions D'installation

Réfrigérateurs et congélateurs intégraux encastrés 36 po
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation Instructions - Stainless Steel Installation

STEP 6 SECURE UNIT TO WALL

• The "L" rods can be found in the upper left and right
corners of the unit in the access compartment. Look
through the access compartment to make sure the
rods line up with the anti-tip bracket.
• There are 2 washers and a hair pin cotter per rod.
Remove the washers and hair pin cotter from the end
of the rod.
• Rotate and move the "L" rod into the slot in the anti-
tip bracket tab.
Once it is in the
slot, rotate the "L"
rod so the hook
portion is pointing
down. The holes
at the front end
of the rod should
be in a vertical
position. Do this to
both sides.
• Pull out on the end of the rod to make sure it is
secure in the bracket.
• Locate the hole on the rod that is closest to the unit.
A hair pin cotter will be put through this hole to secure
the rod. If this hole appears to be too far away for a
snug fit against the unit, add the washers one at a
time until the pin will fit tightly into the hole.
• Align the straight section of the pin with the hole
from the underside of the rod. Push the pin up until it
snaps into position.
Pliers may be used.
NOTE: The hair
pin cotter must be
vertical when this
step is completed to
ensure the "L" rod
is engaged in the
bracket.
• Check the rod for
tightness by pulling
forward. If the rod
moves, remove
the hair pin cotter
and place another
washer on the rod. Reinsert the pin.
• Replace the grille panel.
"L" Rod
Wall Bracket
"L" Rod

STEP 7 ADJUST DOOR SWING

NOTE: This appliance has a 3-position door stop.
When space does not allow the door to swing open
fully to 115°, you may change the door swing to a 90°
opening. A 130° door swing is available for standard
installation only. Skip this step if door opening is
satisfactory for your installation situation.
• Open the grille to view the top hinge. Note the door
stop pin locations. The pin is factory-installed in the
115° position.
• Use pliers to unscrew the door stop and reinstall into
the 90 degree or 130 degree position. Close the
grill.
50
Pin Location
for 90°
Door Swing
Pin Location
for 130°
Door Swing
Pin Location
as Shipped
for 115°
Door Swing

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Zifs360nhrh

Table des Matières