Monogram ZIFS360NHLH Instructions D'installation page 8

Design Guide - Standard Installation
CLEARANCES
25"
Min. to
130° Door
Wall
Swing
130°
These units are equipped with a 3-position door stop.
The factory set 115° door swing can be adjusted to
90° or 130° if clearance to adjacent cabinets or walls
is restricted. Order WX14X99 door stop for precise
settings between 90° and 130°.
When Installed into a corner:
Allow 25" (63.5 cm) for a full 130° door swing. Allow
15" (38.1cm) for pan removal. Allow 4" (10.16 cm)
min. clearance when door swing is adjusted to a 90°
opening for pan access, but pan removal is restricted.
Clearances for Multiple Single Door Installations
In a side-by-side installation of a left and right door
swing product, a 1" (2.54 cm) clearance between
the units is required. Order ZUGSS2 Stainless Steel
Unified Grille Panel Kit or ZUG2 Custom Panel
Unified Grille Panel Kit for one continuous grille
panel.
INSTALLATION
ZUG2, ZUGSS2 Unified Grille Panel Kit
• If you are installing two units, side by side, the installation
space must be 71-1/2" (181.61 cm) wide.
NOTE: Additional cutout width may be required when side
panels are used. Add side panel thickness to the finished
cutout to calculate rough-in width.
• The water and electrical locations for each product must
be located as shown.
• A separate 115V, 60Hz., 15 or 20 amp power supply is
recommended for each product.
Clearances for two products installed side-by-
side with the same (left or right) door swing
Allow 2" (5.08 cm) minimum clearance between the
products to prevent door swing interference. Order
the WX14X99 adjustable door stop to reduce the
factory set 115° door swing. Allow 15" (38.1cm)
minimum to a wall to achieve full drawer extension
and pan removal.
NOTE: ZUG2 and ZUGSS2 Grille Panel Kit will NOT
fit this installation.
Clearances for two products installed side-by-
side with right and left side hinges together Allow
5" (12.7 cm) minimum between the two products to
prevent one door from striking the other. Use the
WX14X99 adjustable door stop to reduce the factory
set 115° door swing and to allow pan removal.
NOTE: ZUG2 and ZUGSS2 Grille Panel Kit will NOT
fit this installation.
8
2"
15"
5"
31-49140-2