Installation Instructions - Stainless Steel Installation
STEP 4 INSTALL ANTI-TIP BRACKET (cont.)
• Gently pull back at the ends of the plastic straps to
make the channel rest flush behind the wall.
• Hold the ends of the straps in one hand and slide the
plastic cap along the straps until the flange of the cap
is flush with the wall.
Cap
• Place your thumb between the plastic straps and
bend up and down to snap the straps off at the wall.
Install Screws and Bolts:
• Have someone hold the wall bracket centered in
place with each of the holes aligned with the correct
opening in the bracket and level with the horizontal
line.
• Insert the lag screws through the bracket and into the
stud. Tighten with a wrench.
Lag Screw
Anti-Tip Wall Bracket
• Insert the bolts into the toggle by hand until snug.
Tighten with a wrench.
Bolt
Anti-Tip Wall Bracket
Wood Stud
Drywall or
Steel Stud
Wall Toggle
Remove Grilles for Access to Anti-Tip Locking Hooks
Fresh Food Unit
• Open the access door.
• Remove the 4 screws from the grille on the right and 3
screws from the grille on the left.
• Pull the bottom of the grille forward, down and out to
remove.
Screws
Freezer Unit
• Open the access door.
• Remove the 4 screws from the grille on the right and 3
screws from the grille on the left.
• Pull the bottom of the grille forward, down and out to
remove.
Screws
Power Cord
Locate the power cord inside the left cavity. If it has not
been adjusted so the plug is easily accessible, do so
now.
48
Screws
Screws