Step 7 Adjust Door Swing; Step 8 Install Grille Panel - Monogram ZIFS360NHLH Instructions D'installation

Installation Instructions - Flush Installation

STEP 7 ADJUST DOOR SWING

NOTE: This appliance has a 3-position door stop.
When space does not allow the door to swing open
fully to 115°, you may change the door swing to a 90°
opening. Skip this step if door opening is satisfac-
tory for your installation situation.
Pin Location
for 90°
Door Swing
• Open the grille to view the top hinge. Note the door
stop pin locations. The pin is factory-installed in the
115° position.
• Close the door. Use Pliers to unscrew the door stop
and reinstall in the 90 degree position. Close the grill.
WARNING
d
Hazard
Improper installation can lead to a finger pinch point
hazard between the side door trim and the cabinets
when operating the door, especially with children.
To minimize this risk you must follow the installation
instructions for cabinet dimensions, trim assembly, and
door stop angle.
AVERTISSEMENT
d
de doigts
Une installation incorrecte peut poser un risque de
coincement de doigts entre la garniture de porte latérale
et les armoires en actionnant la porte, en particulier pour
les enfants. Pour réduire ce risque, vous devez suivre les
instructions d'installation relatives aux dimensions d'armoire,
au montage des garnitures et à l'angle de l'arrêt de porte.
Pin Location
as Shipped for
115°
Door Swing
Door Trim Pinch Point
Risque de pincement
STEP 7 ADJUST DOOR SWING
(Cont.)
ADVERTENCIA
con el Borde de la Puerta
Una instalación inadecuada puede conducir a riesgos de
pellizcos de dedos entre el borde lateral de la puerta y los
gabinetes al utilizar la puerta, especialmente con los niños.
A fin de minimizar este riesgo, usted deberá seguir las
instrucciones de instalación para dimensiones de gabinetes,
ensambles de bordes y esquinas de detención de puertas.

STEP 8 INSTALL GRILLE PANEL

• Raise the access panel to the stop position.
• Loosen the screws on the side trim behind the frame.
Remove the bottom trim.
• Slide the panel over the metal backer panel and into
the trim.
• If necessary, tap with a wood block until the panel
slips under the top trim piece.
• Reassemble the bottom trim. Tighten the screws.
37
Riesgo de Lastimadura
d