Publicité
Les langues disponibles
Les langues disponibles
- Pump seal work. Have it replaced.
- The nozzle is partially blocked. Clean it.
The device 'hiccups'
- After release, the trigger was squeezed in too quickly. After releasing, wait at
least 3 seconds before squeezing the trigger again.
The machine stops
- Fuse burnt out. Replace it and switch other equipment off.
- Check that the socket has the correct Voltage.
- The thermal safety feature is activated. Allow it to cool and remove the cause of
the overheating.
- The nozzle is partially blocked. Clean it.
The fuse burns out
- The electrical installation is too light. Connect the machine to an installation that
has greater Amperage than the machine. Do not use an extension cable.
The machine vibrates
- Air in the water supply hose. Allow it to escape by running water through the
machine while it is switched off.
- Problems with the water supply. Does it meet the requirements? Do not use an
excessively long or thin hose (min. ½").
- The nozzle is partially blocked. Clean it.
- Water inlet filter is dirty. Clean it
- There is a kink in the hose. Straighten it.
The machine regularly starts and stops by itself
- Pump or spray lance are leaking. Have them repaired or replaced.
The machine starts but does not supply water
- Pump, hose or accessories are frozen. Allow them to thaw and then check them.
- No water supply. Ensure that there is a water supply.
- Filter blocked. Clean the filter.
- Nozzle blocked. Clean the nozzle.
Please contact your dealer if there are any other problems!
40
Publicité
