Publicité
Les langues disponibles
Les langues disponibles
Fitting the terrace cleaner
Attention!
Place the cleaner as close as possible to the water supply.
The cleaner must be placed on a strong, flat and horizontal surface (handle up).
The water supply must supply at least the water consumption of the machine
(400 l/h)! The pump must always be supplied with sufficient water. 'Dry
operation' causes damage.
The water temperature may not exceed 40°C. The pressure of the water
supplied may not exceed 0.7 MPA (7 bar).
Only use clean water with this machine. Impurities or aggressive chemicals
damage the machine!
Operation
Turn the On/Off switch to the O / OFF position.
Check that the specifications of the socket that you wish to use correspond with
those on the type plate of the machine. If this is the case, insert the plug into
the socket.
Open the water supply completely.
Unlock the safety lock by pushing the button to the right
Now squeeze the trigger for several seconds in order to de-aerate the hose.
Switch the machine on by switching the On/Off button to I / ON. The motor will
start briefly, but will stop again as long as the trigger is not squeezed.
Now squeeze the trigger – the machine will start.
Take note! Wait at least 3 seconds after releasing the trigger, before squeezing
it in again. If this is not done, the device will 'hiccup'.
The automatic start/stop system means that the motor only works when
the trigger is squeezed.
The jet produced by the jet lance can be adjusted from narrow to wide by
turning the head of the lance. Never do this while spraying!
The Rotating jet nozzle creates a narrow rotating jet.
The terrace cleaner is intended for the cleaning of hard, even, flat surfaces such
as terraces, small streets, steps, (garden) walls, etc. The cap provides protection
from water splashing back. Attention: the powerful jets can damage softer
materials such as paint and wood, etc!
Important: Always point the jet down!
37
Publicité
