Flashing Battery Level Indicator On The Remote Control - American Standard SpaLet Advanced Clean 3.0 Manuel De L'utilisateur

Flashing Battery Level Indicator on the Remote Control

The battery LED on the home screen flashes when the batteries are low. (+ Page 21)
[CAUTION]
● Install batteries in the correct orientation of polarity
as illustrated on the remote control display.
● Do not use a mix of new and old batteries.
● Use alkaline batteries only.
● Be careful not to touch any switches on the remote
control when replacing batteries.
Replacing Remote Control Batteries
n Lift the remote control out of the holder.
1
(Reference)
● The battery LED will flash when the batteries are low. This LED normally does not appear.
● The batteries supplied with the SpaLet
service life than typically available batteries.
● Batteries may become fully discharged before the battery LED flashes depending on the size of the room and
material/color of the walls, particularly with darker colors.
● When replacing batteries, wait for the battery LED to disappear after the batteries have been removed before insert-
ing the new batteries. This is because the battery LED may remain flashing after batteries have been replaced.
41 - EN
n
2
Remote Control
Holder
n
3
®
seat are used for operation checks at the factory, and so it has a shorter
Remove the back cover and replace with
two new 1.5-V AA alkaline batteries.
* If the back cover is difficult to remove, use a flat-
blade screwdriver or similar tool to release the lock.
Lock
Alkaline batteries
Return the remote control into the holder.
Battery LED
Back cover