Replacing Nozzle Tips - American Standard SpaLet Advanced Clean 3.0 Manuel De L'utilisateur

Replacing Nozzle Tips

When stains cannot be removed from the nozzle tips, the nozzle tips can be replaced with new parts.
Removing the Nozzle Tips
n Raise the seat lid and SpaLet
1
n Press the [Nozzle Cleaning] button.
2
* The back cleansing nozzle extends.
* After water flows out from the nozzle area for
approximately 10 seconds, the back cleansing nozzle
extends, but the nozzle does not discharge any water.
[Nozzle Cleaning]
< Replacing the front cleansing nozzle >
Press the [Nozzle Cleaning] button again.
* The front cleansing nozzle extends.
[Nozzle Cleaning]
[CAUTION]
● ● The nozzle tips cannot be replaced if a person is
sitting on the SpaLet seat.
37 - EN
®
seat. n Turn the nozzle tip counterclockwise and
3
align the Detach mark on the right side of
the nozzle tip with the Center mark on the
nozzle wand, and then pull out the nozzle
tip.
* Pull the nozzle slightly, hold the nozzle at its base
with your hand, and then remove the nozzle tip.
Turn
counterclockwise
* While the nozzle is held in place, install a new
nozzle tip according to the procedure described in
"Installing the Nozzle Tips" (+ Page 38).
①
O-ring
Center mark
②
Pull
Detach mark
Center mark