Draining the Water to Prevent Freezing
n
Set the [Seat Temp.] to "High" and close
1
the seat lid (+ Page 10).
n
Turn off any active power save function
2
(+ Page 18).
n
Manipulate the water drain plug in your
3
building to drain water from the pipes.
* Do not close the water shut-off valve when manipu-
lating the water drain plug.
* Refer to the drain plug User Manual for more infor-
mation on the exact procedure.
n
Move the flush lever to drain water from
4
the toilet tank.
n
Drain water from the toilet body
5
n
,
3
* Refer to steps
and
procedure on page 40 to drain the water from the
toilet bowl.
[CAUTION]
● ● When removing the strainer, be careful not to
damage the water supply hose.
Press and hold the [Nozzle Cleaning] and [Massage]
simultaneously for at least 2 seconds.
* The water remaining in the seat unit drains out for
approximately 15 seconds.
Raise the water supply hose attached to the seat
unit to drain water completely from the hose.
Seat unit water
supply hose
n
After the water is drained, hold the water
6
supply socket with your hand, and tighten
the strainer firmly using the tool.
Tighten until the end surface
of the strainer is flush with
the socket end surface.
n
,
4
of the "Draining Water"
Turn clockwise
■ If water has frozen and the spray does not operate
If the water supply hose or water supply connec-
tions have frozen and the spray does not operate,
use a cloth immersed in warm water to warm the
water supply hose or water supply connections to
slowly thaw them, or warm the bathroom and allow
them to thaw naturally.
[CAUTION]
● Do not pour hot water or blow hot air over the water
supply hose.
* Doing so may result in damage to the water supply
hose.
● Water may be discharged during the thawing pro-
cess depending on the parts being warmed. Confirm
the condition regularly during the thawing process.
24 - EN