American Standard SpaLet Advanced Clean 3.0 Manuel De L'utilisateur page 38

Cleaning Nozzle Areas
Extending Nozzles/Opening Shutters [Ejecting Nozzles]
The nozzle can be ejected for cleaning or to replace tips.
The nozzle shutter can be opened and removed, and the deodorizing filter can also be removed.
n Open the seat lid and the SpaLet
1
n Press the [Nozzle Cleaning] button.
2
* A nozzle shutter will open, then nozzle moving back
and forth while spraying water to wash the back noz-
zle and front nozzle. It washes alternately for about
80 seconds.
* The nozzle will automatically retract after approxi-
mately 5 minutes.
After the nozzle has retracted, press the [Nozzle
Cleaning] button again to extend the back nozzle
again.
n Press the [Nozzle Cleaning] button.
3
* The back nozzle retracts followed by ejection of the front nozzle.
* The nozzle will automatically retract after approximately 5 minutes.
After the nozzle has retracted, press the [Nozzle Cleaning] button two times to extend the front nozzle again.
n Press the [Nozzle Cleaning] button.
4
* The nozzle shutter opens.
* The nozzle shutter opens to enable removal of the shutter or cleaning of the deodorizing filter.
* Refer to the "Removing the Nozzle Shutter" and "Cleaning the Deodorizing Filter" sections. (+ Page 39)
n Press the [Stop] button to return the nozzle shutter to the original position.
5
* If the nozzle catches, perform the procedure to eject the nozzle again.
[CAUTION]
● Do not apply excessive force to nozzles.
* Doing so may cause malfunction.
● Do not manually force the nozzle forward or backward.
* Doing so could cause a malfunction such as the nozzle not moving correctly. If the nozzle is incorrectly pulled
forward or pushed backward, disconnect the power plug from the outlet and wait approximately 10 seconds
before reconnecting the power plug.
● Do not scrub with a toothbrush.
* Doing so may cause damage.
35 - EN
®
seat.
[Nozzle Cleaning]