Gsm Module Configuration - DAB EEG0,75T3 S Serie Instructions De Mise En Service Et D'entretien

[127] Fault inverter: power supply
directly from mains.
Enables pump operation directly from the
mains in the event of a fault in the
inverter.
IN BOOSTER OPERATION
STARTING/STOPPING
PUMPS IS CONTROLLED BY THE
TRANSDUCER BETWEEN
RESTARTING PRESSURE AND THE
DANGER PRESSURE.
CAUTION, HIGH PRESSURE IN THE
SYSTEM!!
The circulators are controlled by the
remote control if present.
[305] System supervisor
OFF – no supervision;
GSM – supervision by the additional
module GSM;
[306] GSM text message
Allows you to choose every how many
days to receive SIM credit on your phone
11.4

GSM MODULE CONFIGURATION

- Carry out installation and the first start-up procedure as indicated in the manual of the GSM module, referring to
the drawing below for references concerning this panel.
Fig. 8
-
After installation and the first start-up, check that there is no indication of the alarm AL5.
-
Check the sending of an alarm SMS by causing an alarm situation, for example temporarily disconnecting the
jumper or the minimum pressure switch between terminals 15-16 (or 7-8 depending on the settings).
In the event of an alarm the GSM module will send a message containing the description of the active alarms.
-
-
-
-
-
OFF - ON
THE
OF THE
THE
OFF, GSM
KL5
pump maintenance;
parameters error;
faulty sensor;
motors thermal protection;
inverter alarm;
ENGLISH
Field Default
OFF
OFF
0-:-60 gg 14
-
no communication with inverter;
-
overpressure;
-
lack of water;
-
maximum level;
-
minimum pressure.
91
KL1
XC1
CN1
LOCAL
PC
CN3
REMOTE
PC