DAB EEG0,75T3 S Serie Instructions De Mise En Service Et D'entretien page 81

REFERENCE
LL4
Green warning light indicating electropump two running.
Ref. Photo 10.1
LL5
Green warning light indicating electropump three running.
Ref. Paragraph 10.1
Red warning light indicating thermal block of electropump one.
LL6
-
blinking light for the first three interventions, fixed light at the fourth
intervention.
Ref. Photo 10.1
Red warning light indicating thermal block of electropump two.
LL7
- blinking light for the first three interventions, fixed light at the fourth
intervention.
Ref. Photo 10.1
Red warning light indicating thermal block of electropump three.
LL8
- blinking light for the first three interventions, fixed light at the fourth
intervention.
Ref. Photo
Key for selecting panel operation with:
-
-
SB1
-
Ref. Photo 10.1
In EEG panels from 11kW upward there is NO pressure switch
operation.
Key for selecting operation of electropump one in:
-
-
SB2
Ref. Photo 10.1
Press the key
again (the led LL3A lights up).
Key for selecting operation of electropump two in:
-
-
SB3
Press the key
Ref. Photo 10.1
again (the led LL4A lights up).
INVERTER: yellow led LL9 lit.
PRESSURE SWITCH: yellow led LL10 lit: ATT. see chap. 14
SYSTEM EXCLUDED: leds LL9-LL10 both off and control panel
programming enabled.
AUTO: yellow led LL3A lit: the electropump is started by the
control board.
MAN:
yellow led LL3A lit: the electropump is started by holding
down the key for more than 5 seconds. When the key is released,
the electropump stops and the led LL3A goes out.
and select automatic starting of the electropump
AUTO: yellow led LL4A lit: the electropump is started by the
control board.
MAN:
yellow led LL4A lit: the electropump is started by holding
down the key for more than 5 seconds. When the key is released,
the electropump stops and the led LL4A goes out.
and select automatic starting of the electropump
ENGLISH
FUNCTION
79