Filling Solution Tank; Machine Operation; Pre--Operation Checks; Operating The Machine - Nobles Speed Scrub 2001HD Opérateur Manuel Et Liste Des Piéces

FIRST TIME USE (FaST Model): The FaST system is
protected against freezing during shipment. You must
operate the FaST system for 10 minutes to disperse
the mixture of RV anti--freeze/FaST concentrate
before achieving maximum foam.

FILLING SOLUTION TANK

Remove fill port cover at front of machine and fill
solution tank with 64L (17 gal) of clean water. Or use
the rear fill port to fill solution tank. The clear tube
below the fill port has 19L (5 gal) increment markers to
indicate amount of water in tank (Figure 13).
FOR FOAM SCRUBBING (FaST Model) : ONLY FILL
TANK WITH CLEAN COOL WATER (< 21°C/70°F).
NOTE: DO NOT use hot water or add any
conventional floor cleaning detergents, FaST system
failure may result.
FOR CONVENTIONAL SCRUBBING: Fill tank with
water (60°C/140°F maximum). Pour a recommended
cleaning detergent into the solution tank according to
mixing instructions on the bottle.
NOTE: When filling the solution tank with a bucket,
make sure that the bucket is clean. Do not use the
same bucket for filling and draining the machine.
ATTENTION: For Conventional Scrubbing, only
use recommended cleaning detergents. Machine
damage due to improper detergent usage will void
the manufacturer's warranty.
WARNING: Fire or Exposion Hazard.
Never Use Flammable Liquids.
FOR SAFETY: When using machine, follow mixing
and handling instructions on chemical containers.
Speed Scrub 2001HD (03- -05)
FIG. 13

MACHINE OPERATION

FOR SAFETY: Do not operate machine, unless
operatior manual is read and understood.
WARNING: Fire or Explosion Hazard. Never
Operate Machine In Or Near Flammable Liquids,
Vapors Or Combustible Dusts.
PRE- -OPERATION CHECKS
1. Sweep and dust mop the floor.
2. Check battery meter charge level to ensure
batteries are fully charged (See CHARGING
BATTERIES).
3. Check that pad or brush is installed.
4. Check that squeegee is installed.
5. Foam scrubbing (FaST Model): Check the
FaST--PAK concentrate level.
6. Foam scrubbing (FaST Model): Make sure the
solution tank is filled with only cool clean water, no
detergents.

OPERATING THE MACHINE

NOTE: If your machine is equipped with the FaST
Option, refer to page 13 for additional operation
procedures.
1. Adjust control grips to a comfortable operating
height by squeezing the two levers together below
the console (Figure 14).
OPERATION
FIG. 14
11