Installing Fast--Pak Agent; (Fast Model) - Nobles Speed Scrub 2001HD Opérateur Manuel Et Liste Des Piéces

OPERATION
5. Select a recommended pad or brush that best
meets your cleaning needs.
NOTE: Consult your authorized distributor for pad and
brush recommendations.
6. (For Pad Installation) Attach pad to pad driver
before connecting driver to motor hub. Secure with
centerlock ring (Figure 8).
7. Align pad driver mounting studs with slots in motor
hub. Give the driver a quick turn toward the motor
hub spring clip. Be certain that the spring clip
locks into one of the studs before operating
machine (Figure 9).
NOTE: Always make sure pad driver and motor hub
surfaces are clean before installing driver. Clean
surfaces will ease pad driver removal later.
8. Close skirt housing and refasten latch.
INSTALLING FaST- -PAK AGENT (FaST MODEL)
1. Remove the perforated knock-out from the
FaST--PAK carton. Do not remove the bag from
the carton. Pull the hose connector through the
knock--out and remove the orange cap
(Figure 10).
ATTENTION: The FaST- -PAK Concentrate Formula
is specifically designed for the FaST system.
NEVER use a substitute, machine damage may
result.
10
FIG. 8
FIG. 9
FOR SAFETY: When using machine, always follow
the handling instructions on chemical container.
2. Place the FaST--PAK carton in the carton holder at
the rear of the machine and connect the supply
hose to the FaST--PAK bag (Figure 11).
NOTE: If any dried concentrate is visible on the supply
hose connector or on the FaST- -PAK connector, soak
and clean with warm water.
3. When the supply hose is not in use, make sure to
connect it to the storage plug (Figure 12). This will
prevent the FaST solution system from drying out
and clogging up the supply hose.
FIG. 10
FIG. 11
FIG. 12
Speed Scrub 2001HD (09- -04)