Machine Maintenance; Daily Maintenance - Nobles Speed Scrub 2001HD Opérateur Manuel Et Liste Des Piéces

7. After charging, check the electrolyte level (A)
again. The level should be approximately 1 cm
from the bottom of the fill--port (B) (Figure 32).
Add distilled water if needed. DO NOT OVERFILL.
B
A

MACHINE MAINTENANCE

To keep the machine in good working condition, simply
follow the daily, monthly and quarterly maintenance
procedures.
WARNING: Electrical Hazard. Disconnect
Battery Cables Before Servicing Machine.

DAILY MAINTENANCE

(After Every Use)
1. Drain and clean out the recovery tank.
2. Remove and clean the float shut--off screen
located in the recovery tank (Figure 33).
3. Drain the solution tank and rinse out the inside
with water (60°C/140°F maximum) as needed.
4. Remove the pad/brush and clean. Rotate pad or
replace when worn.
Speed Scrub 2001HD (03- -05)
FIG. 32
FIG. 33
5. Wipe the squeegee blades clean. Store the
squeegee assembly in the raised position to
prevent blade damage.
6. Check the condition of the squeegee blade wiping
edge. Rotate blade if worn (See SQUEEGEE
BLADE REPLACEMENT)
7. Clean the machine with an all purpose cleaner and
damp cloth (Figure 34).
FOR SAFETY: When cleaning machine, do not
power spray or hose off machine. Electrical
malfunction may occur.
8. FaST Model: Connect the FaST--PAK supply hose
to the storage plug when not it use (Figure 35).
Remove any dried concentrate from the hose
connector by soaking it in warm water.
9. Recharge the batteries after a total of 30 minutes
of use or more (See CHARGING BATTERIES).
OPERATION
FIG. 34
FIG. 35
17