Table des Matières
Publicité
OPERATION
6. To move the machine left (A), slightly lower the
handle. To move right (B), slightly raise the
handle. Operate the machine with a side to side
motion (Figure 6).
A
FIG. 6
7. To stop machine, rotate the twist grips backwards
and hold handles firmly until machine comes to a
complete stop. The safety lock button will
automatically engage.
FOR SAFETY: When using machine, do not
release handles until pad comes to a complete
stop.
NOTE: The machine's circuit breaker may trip under
conditions of excessive overload. Change to a less
aggressive pad/brush and periodically check pad for
soil build–up. To reset circuit breaker switch, wait 15
seconds and press the reset button located on the
handle.
8. Do not operate the machine in the same spot for a
long period of time. Floor damage may result.
9. To maneuver over thresholds and floor grates,
stop the machine and tilt it back on the transport
wheels.
10. When machine is not in use, do not leave machine
standing on the pad/brush. Pad/brush damage
may result.
11. When done scrubbing perform the following
machine maintenance procedures.
12
All manuals and user guides at all-guides.com
OPERATING THE OPTIONAL SOLUTION TANK
1. Remove cover and fill the solution tank with a
2. Lower handle to working position. Pull the solution
Operate Machine In Or Near Flammable Liquids,
Vapors Or Combustible Dusts.
This machine is not equipped with an explosion
proof motor. The electric motor will spark upon
start up and during operation which could cause a
flash fire or explosion if machine is used in an
area where flammable vapors/liquids or
B
combustible dusts are present.
MACHINE MAINTENANCE
FOR SAFETY: Before leaving or servicing
machine, unplug cord from wall outlet.
1. Remove and clean the pad driver/brush after each
2. Clean the machine base after each use.
3. Inspect power cord for damage after each use. If
4. Wipe the power cord with damp cloth and neatly
5. Periodically check that all bolts and nuts are tight.
6. Every 250 hours of operation, check the motor for
Power Cord. Do Not Modify Plug. Unplug Power
Cord Before Servicing Machine.
Speedshinet 1700LS/1700HD/1700DS/2000LS/2000HD/2000DS (09–02)
recommended solution. Replace cover after filling.
control knob to disperse solution to the pad/brush.
WARNING: Do Not Use Flammable Liquids Or
use.
worn or damaged, replace immediately.
coil it around cord hook and handle after each use.
carbon brush wear. Replace brushes when worn
to a length of 1 cm (3/8 in) or less.
WARNING: Do Not Operate With Damaged
Publicité
Table des Matières
