Güde GH 9 E Traduction Du Manuel Original page 10

Qualification
No special qualification is necessary for using the appliance
apart from detailed instruction by an expert.
Minimum age
The appliance can only be operated by persons over 16 years
of age. An exception includes youngsters operating the
appliance within their professional education to achieve
necessary skills under trainer's supervision.
Training
Using the appliance only requires appropriate instructions by
a professional or reading the Operating Instructions. No
special training necessary.
Technical specifications
Voltage:
Frequency/protection type:
Max. heating output:
Heating levels:
Input:
Fan output:
Weight app.
Art. No.
Transport and storage
The appliance may be transported using the travel
handle.
Appliances not being used should be kept in a dry
and locked room.
Operation (pic. 2 + 3)
The appliance may be put into operation after reading and
understanding the general safety instructions and
appliance-specific safety instructions. In doing so, proceed
as follows:
To reach optimum heat distribution, put the electric heater in
the middle of the room if possible or at least 1 m from the
wall. With this, air will circulate better and the room will get
warm quicker. All windows and doors must remain closed.
Connection (pic. 2):
Put the feeder cable to a suitable outlet.
Make sure your electrical network is protected
appropriately.
GH 9 E Electric Heater
400 V
50 Hz/IP 44
9 kW (7700 kcal./h)
4,5 kW/9 kW/ Fan
13 A
3
780 m /h
13 kg
85104
10
Operation (pic. 3):
Use the thermostat regulator and set the required
switch-off temperature.
The function switch has 4 switch levels
0
= off
*
= ventilation
= half heating output
= full heating output
To switch the electric heater off, let the function button in the
"Fan" position for app. 3-5 minutes. The appliance may then
be switched off or unplugged.
Never unplug the appliance when hot – let it cool down
first. The fan may still ventilate even when in the off position.
Power consumption corresponds to the sum of the heating
output (kw) and fan output.
Thermostat setting
Set the thermostat to the average switch-off
temperature.
Set the electric heater to the full heating output and let it
heat until the thermostat switches off. - until you hear
"snapping in".
After reaching the set temperature, the heating spiral
switches off and the fan keeps running to circulate the
air. As soon as the temperature drops, the heating spiral
switches on again.
If the room temperature is too low, turn the thermostat
regulator more to the right and switch the heater on
again.
If the room temperature is too high, turn the thermostat
more to the left and let the room get cooler.
Keep repeating these steps until reaching the required
switch-off temperature.
Attention: For the first commissioning of the electrical
heater, it can sometimes be an unpleasant odor which
is completely harmless and completely disappears with
increasing operating time.