6.10 Acquisition Procedure For Single-Shutter With Slowing; Operation Sequence; Acquisition For Single-Shutter With Slowing - Aprimatic G-MATIC AP350 Notice D'installation Mécanique, D'utilisation Et D'entretien

6.10 ACQUISITION PROCEDURE FOR SINGLE-SHUTTER WITH SLOWING

Regulate the TORQUE trimmer to the minimum degree necessary to make the gate move properly and regulate the
SLACK slowing force trimmer to the minimum value necessary to make the gate open properly.
6.10.1

Operation sequence

•
Close the gate completely.
•
Press the PROG.A learning button until the DL6 LED flashes and DO NOT release the PROG.A button until the
DL6 flash gets quicker.
•
Release the PROG.A button
•
Press START: the first shutter begins to open at standard speed
•
When you decide to start the slow-stroke phase, press START: the slow-stroke phase starts
•
When the shutter has opened completely, press START: the shutter begins to close at standard speed
•
When you decide to start the slow-stroke phase, press START: the slow-stroke phase starts
•
When the shutter has closed completely, press START
•
Wait until the DL6 LED turns off.
•
Acquisition finished
•
The subsequent manoeuvre will be standard within the parameters just set
12 sec).
6.10.2

Acquisition for single-shutter with slowing

DS41035-001
After resetting or after supplying the board, the first closing manoeuvre time is longer (about
32
LBT0197