Slowing Down The Operator Opening C29; Final Assembly - Aprimatic ZT42 Mode D'emploi

R
3.9.3 Slowing down the operator opening
(C29)
To use the opening slowing-down (only for ZT44 SF
DS version), it is indispensable to use the entire stroke
length of the rod.
In the ZT44 SF DS version, with the rod fully withdrawn,
12 mm will protrude.

3.9.4 Final assembly

Fit the protective casing (E1 pos. 1) to the arm,
positioning it against the operator.
Fix the casing(E2 pos. 2) into position on its underside,
using a cross-head screwdriver (E2 pos. 3).
Fit the push-on cover (E3 pos. 2) on to the protective
casing (E3 pos.1).
Tighten the fi xing screw (E4 pos.1) of the protective
casing.
On completion of the assembly, remove the bleed screw
(E5 pos. 4) using CH7 hexagonal wrench.
Caution
One drop of hydraulic oil coming out of the duct
created by the screw elimination (E5 pos. 4) is
normal.
If necessary, fit the protective sheath to the power
supply cable (E5 pos. 5).
C29
E1
E3
1
2
E5
- 23 -
Installation
C29
E2
E4
1