Ap 350 Electronic Equipment; Description - Aprimatic G-MATIC AP350 Notice D'installation Mécanique, D'utilisation Et D'entretien

6

AP 350 ELECTRONIC EQUIPMENT

6.1

DESCRIPTION

The electronic equipment Type AP 350 can be used to control two actuators for a double-sided gate with a maximum
power of 300W per motor. The max. absorption of the device is 650W per 230V 50Hz. The set-up of the parameters
must be carried out after the installation of all the equipment.
operations strictly in compliance with safety rules. The product must not be used incorrectly or for any purposes for which
it was not designed. Before proceeding with the installation it is necessary to read the instruction manual carefully in
order to avoid dangers to either the users or the equipment. It is necessary to power the equipment using a 6A bipolar
the magnetic switch equipped with a differential with an operating current of 0.03 A. Before carrying out any installation
or maintenance operations turn off the power supply to the device with the bipolar switch. The equipment must not be
tampered with or modified in any way. It is necessary to turn off the power supply to the equipment before installing it or
opening the container.
Therefore this manual may not correspond exactly to product specifications..
DS41035-001
The product must be installed by qualified personnel who can carry out the installation
The manufacturer reserves the right to make changes to the product without giving notice.
Reference
TR1 ÷ TR3
Trimmers
DSW1 Dip switches
DL1 ÷ DL6
Segnalation LED
DL7 Programming LED
F1 230V Fuse
F2 Low voltage fuse
M1 Signal terminal board
M2 Power terminal board
CN1 Receiver
K1 ÷ K3
Relays
TF1 Transformer
U1 Microprocessor
JR1 Reset jumper
P1 Strokes programming key
P2 Remote control programming Key
Description
24
LBT0197