Local Settings - AERMEC CC2 Manuel D'utilisation/Installation

EN
5.12.

LOCAL SETTINGS

Press on the homepage to access the settings page. Press the "Local Setting" button to switch to the setting options of the
current unit. Select the desired option on the left side of the column. Turn the page by scrolling up or down. Set the corresponding
content on the right side. The local settings include: Sound, temperature unit, time format, mutual exclusion. Press the button to
select a setting type.
• Language: Press the button to select the system language, such as English, Simplified Chinese, or Traditional Chinese.
• Set time : Setting the date and time of the centralized control system.
• Password: The user password can be enabled or disabled by pressing the button. If the password is enabled, it can be set or
modified with 4 ~ 10 numbers or characters. The original password is blank. Press button
user password is enabled, the user must enter a password to access the control page when the centralised controller is on or
activated.
• Backlight settings: Pressing this button sets the timeout of the screen's backlight. The screen shuts off and the centralised
controller switches to sleep mode after the timeout has ended. N.B.: When the centralised controller is in Sleep mode, the user
can activate it by touching any point on the touch screen or the touch button on the bottom right of the screen.
• Brightness: Pressing or dragging the scroll bar changes the backlight level.
• Customer support: The user can set the name and phone number of the local customer support center for immediate
solutions and technical support. Press button
• Restore the default settings: Press the "Reset" button to reset the local settings, the electronic control settings, the group
settings, schedule settings, indoor unit names and icons, and other factory default settings.
1. When switching between the indoor and outdoor network or when resetting the unit's IP, reset the factory settings for the
centralised controller.
2. Once the setup of the centralised controller has been completed, connect it to the network. If the centralised controller is
connected to the network during the setup process, the factory settings must be reset.
42
Fig. 5.11 Settings page
to save the settings.
to save the password. N.B.: If the