Safety Instructions; User Notice - AERMEC CC2 Manuel D'utilisation/Installation

EN
• The use of the unit is not recommended for people (including children) with reduced physical, sensory or
mental capabilities, as well as operators lacking experienced and knowledge, except in the presence of a
safety officer able to
• provide supervision and adequate instructions for use. Do not allow children to play with
• the equipment.
• All illustrations and information contained in this manual are purely indicative; for the actual control of the
functions related to the device, refer to that which appears on the controller's display.
• In order to improve the product, we reserve the right to modify or revise this document without prior notice;
therefore remember to periodically verify the presence of new versions.
• Aermec will in no case be liable for any damages to property and/or persons caused by improper operations
such as: incorrect installations, debugging or maintenance not carried out, non-compliance with the
installation regulations foreseen in the country where the device will be installed or non-compliance with the
rules contained in this manual

1. SAFETY INSTRUCTIONS

ATTENTION: the unit is not suitable for installations in a corrosive, flammable or explosive environment, or in places
requiring special requirements (such as kitchens); the installation in such environments could jeopardize the operation
of the unit or in more severe cases cause fire or serious damage to property and/or persons.

2. USER NOTICE

• All indoor units must be powered with a correct voltage.
• Make sure the communication cable is connected to the correct port, otherwise communication failures may
occur.
• Do not hit or throw the centralized controller or unplug it frequently.
• Do not start the centralized controller with wet hands.
• Do not scratch the screen if the centralized controller with hard or sharp objects.
• If the centralized controller is connected to the external network or to the last indoor unit of the internal
network, a corresponding resistor must be connected between ports G1 and G2.
• If the centralized controller is connected to the LCI units, each indoor unit must be set with a unique address
from 1 to 36.
24
General warnings
If the rules marked with this symbol are not complied with, serious damage to the unit or injury to the
If the rules marked with this symbol are not complied with, minor
damage to the unit or injury to the people using it may occur
This symbol expressly prohibits potentially very dangerous operations
This symbol indicates operations or indications that must be respected in order to avoid damage to
people using it may occur
property and/or persons