Lci Units General Control Parameters - AERMEC CC2 Manuel D'utilisation/Installation

EN
No.
(5) Error condition
(6)
Unit registration
(7)
(8) General Off
Change page
(9)
(10) General On
(11) Indoor unit Icon
(12) Indoor Unit name
Before using the centralised controller to manage the LCI units, remember that these units must be registered in the controller with
key (7) shown in the previous table (remember that the system can manage up to 36 LCI units) ;
Pressing and holding the icon of an LCI unit accesses the page to set the name and icon to assign to the unit;
The control of the LCI units foresee general parameters and advanced parameters;
Notes:
Group control is not available for LCI units;
If the general control is used to pilot all the indoor units together (chapter 5.6), the settings specified in the advanced settings
page ("Advance" icon) will not apply to the LCI units;
5.10.

LCI UNITS GENERAL CONTROL PARAMETERS

• ON/OFF: Press the on/off button to activate or deactivate the unit. When the unit is deactivated the mode, temperature, fan
speed and swing can not be set.
• Mode setting: Press the Mode buttons to set the operating mode of the unit. The modes for the indoor units of the different
series are not the same. If a certain mode is not present in the indoor unit, the icon of the corresponding mode can not be
selected.
1. The AUTO mode can only be set on the master indoor unit.
2. A master unit is not foreseen in 3-pipe systems. In 3-pipe systems, if multiple indoor units are connected in parallel to a single
output of a distributor, the automatic mode will not be available for these units, whereas if just one unit is connected to the
output of a distributor, the automatic mode can be set on that indoor unit.
• Temperature setting: Press the up or down button to adjust the temperature. Each time the button is pressed, the temperature
increases/decreases by 1. By holding down the button, the temperature increases/decreases continuously. By pressing
button the "indoor temp" and "outdoor temp" are displayed.
• Setting the ventilation speed Press the Fan speed button to set the fan speed of the unit. N.B.: The default unit is set to a low
fan speed in dehumidification mode. The fan speed can not be set in dehumidification mode or floor heating mode.
• Setting of the continuous swing function: The swing function is activated or deactivated by pressing the "Up & Down Swing" or
40
Name
The error icon is displayed if the indoor unit is not working properly.
Lock This icon is displayed when the indoor unit is in the locked status.
This button allows to access the registration page for the LCI units on the system; the units
must be registered in order to be managed by the centralised controller,
Press this button to disable the entire air conditioning system.
The icon indicates the current page displayed, as well as allowing to move between the
pages using the right and left arrow keys
Press this button to activate the entire air conditioning system.
Display of the indoor unit icon.
Display of the indoor unit name.
Fig. 5.9 Single indoor unit control page
Function
Notes: