Advanced Control Parameters; Control Of The Entire System - AERMEC CC2 Manuel D'utilisation/Installation

EN
5.5.

ADVANCED CONTROL PARAMETERS

Press the Advance button to access the advance page.
Press the icon buttons to enable or disable the corresponding function.
• The Sleep, Quiet, Auto quiet, E-heater, Absence, Rapid, and Save functions are effective when the unit is active.
• When the Sleep function is active, the Auto quiet function is activated accordingly. The SLEEP function is not active the auto
mode, fan or floor heating active.
• The Absence function activates only with the heating mode. When the Absence mode is active, the temperature set is 8°C
• The Rapid cool function is only effective in the cooling mode. Likewise, the Rapid heat function is only effective in heating
mode.
• When the Shield All function is active, the other Shield buttons are not valid.
• N.B.: When the centralised controller connects to different units, some functions will also be different for the different units.
5.6.

CONTROL OF THE ENTIRE SYSTEM

Press on the homepage to access the All.Control page.
The All-control function activates all indoor units as follows:
• ON/OFF: Press the on/off button to activate or deactivate all units.
When the unit is off, the temperature, fan speed and swing modes can not be set.
• Mode setting: Press the Mode button to select the operating mode.
36
Fig. 5.3 Advanced functions page
Fig. 5.4 System control page