Technical Settings; Further Information - AERMEC CC2 Manuel D'utilisation/Installation

5.13.

TECHNICAL SETTINGS

Press on the homepage to access the settings page. Press the "Project Setting" button to switch to the technical settings, the
operating method is the same as the settings of this unit.
• Indoor Unit registration Access the indoor unit registry interface, select the indoor unit selected according to the technical
code of the indoor unit icon displayed, then press
displayed. Notes: The maximum of 255 indoor units can be registered.
• Name and icon settings: Go to the Name&Icon setting interface to select the technical code and set the name and icon for
the indoor unit.
Press the technical code to select the indoor unit required to be set.
1. Name: Enter numbers or letters (no more than 10 letters)
2. Icon: press to select the pre-set icon.
3. Engineering No.: settable from 1 to 255.
4. Press to save the settings. At this point, the list of indoor units on the homepage displays the new name and icon of the
indoor unit.
• Project number advanced settings:
To access the unit's advanced settings, press and hold the "project setting" button for 5 seconds when the "Local Setting" key is
selected; the following options are available within this new window:
1. Indoor and outdoor unit advanced setting with indoor and outdoor unit parameter change;
2. Display of the indoor and outdoor unit parameters;
3. Indoor and outdoor unit error log;
4. Displays the project numbers of the unit (when the switch for the project number is ON, the number is displayed on the display
of the wired panel connected to the relative unit);
5. "Project password" settings (the default password is: 123456);
6. Emergency stop via remote control settings; all units will be turned off via the signal on terminals F1/F2, which can manage
24V~5V DC signals;
5.14.

FURTHER INFORMATION

Press on the homepage to access the settings page.
information. The operating method is the same as that of the local settings. On the additional information page, the user can view
information concerning the local unit, the Customer After Sales Service and other notes.
to save, the indoor unit registered on the indoor unit page will be
Fig. 5.12 Indoor unit settings page
Press the "About" button to go to the page with additional
EN
43