Single Unit Control; General Control Parameters - AERMEC CC2 Manuel D'utilisation/Installation

5.3.

SINGLE UNIT CONTROL

On the indoor unit control page or the group page, press the indoor unit icon to access the Single unit control. Press the icon of
the indoor unit for 5 seconds to display set name of the selected indoor unit.
The control parameters of the single unit include the general control and advanced control parameters.
5.4.

GENERAL CONTROL PARAMETERS

• ON/OFF: Press the on/off button to activate or deactivate the unit. When the unit is deactivated the mode, temperature, fan
speed and swing can not be set.
• Mode setting: Press the Mode buttons to set the operating mode of the unit. The modes for the indoor units of the different
series are not the same. If a certain mode is not present in the indoor unit, the icon of the corresponding mode can not be
selected.
1. The AUTO mode can only be set on the master indoor unit.
2. A master unit is not foreseen in 3-pipe systems. In 3-pipe systems, if multiple indoor units are connected in parallel to a single
output of a distributor, the automatic mode will not be available for these units, whereas if just one unit is connected to the
output of a distributor, the automatic mode can be set on that indoor unit.
• Temperature setting: Press the up or down button to adjust the temperature. Each time the button is pressed, the temperature
increases/decreases by 1. By holding down the button, the temperature increases/decreases continuously. By pressing
button the "indoor temp" and "outdoor temp" are displayed.
• Setting the ventilation speed Press the Fan speed button to set the fan speed of the unit.
to a low fan speed in dehumidification mode. The fan speed can not be set in dehumidification mode or floor heating mode.
• Setting of the continuous swing function: The swing function is activated or deactivated by pressing the "Up & Down Swing" or
"Left & Right Swing" button. N.B.: The swing types for indoor units of different series are not the same.
• Troubleshooting: If the indoor unit does not function correctly
Fig. 5.2 Single indoor unit control page
turns red; then press the button to display the fault information.
Notes:
N.B.: The default unit is set
EN
35